Curving Pipes

Note: This is an old page that has been updated/formatted, you can view the original here.

Author: Brian Lozier


This is a brief tutorial on how to create pipes (or anything for that matter) that curve nicely and easily. First of all, create the sector you want to use as a pipe. I created a simple octagon. To do that (for the newbies out there), just switch to the sideview (shift+2) and cleave off the corners of the sector. Then, delete them.

Now, with that pipe sector selected, go to the top view by pressing [shift+1]. Then, press the [Insert] key. This will insert a new sector exactly the same as the old sector.

Now, since we are working on a 90 degree angle to start out, we need to rotate this pipe sector 90 degrees, so it is at a right angle to the original sector. To do that, make sure the new sector is selected, and then go to the "Tools" menu, and press "Tool Window." If you want, you can use the shortcut key [F9].

Now, we want to rotate this sector around the "Z axis" 90 degrees. So, in the window, select "Z axis," type in 180, then press "rotate."

Now, you will end up with two sectors at right angles to eachother. It's easiest to move them so they square up with the grid, as I have in the diagram below.

Now, we have to cleave both of these sectors' ends off at 45 degree angles. That way, they meet up at a 90 degree angle. To do this, just use the grid squares as guides, and cleave from corner to corner. I did this below.

Now, delete the extra sectors as shown below.

Notice that now we have two edges that look like they will fit together nicely. That's the whole point of this tutorial. Next step is to move them together, as shown below.

It is important to check from a side view to make sure they are aligned, as shown below.

The left pic is before I aligned them, the right is after.

Now, select the surface that is common between both sectors, as shown below, and press the "a" key. This will adjoin the sectors and allow you to walk between them.

That's it! Very easy. Below is the finished product.

The rotate tools can be used in many ways.. for instance, you could make your pipe curve straight up or down using the other axis. If you want the transitions to be less, don't use 1 45 degree angle, use less of an angle, but do it twice. I hope that makes sense. That's it for now, good luck on your pipes.